Ford       

1-Matchmark drive shaft so the same orientation can be maintained upon reassembly. This will help drive system in balance.

2-Fully support transmission: Clamp, bolt or securely chain to transmission stand.

3-It is helpful to replace two mounting bolts with studs to serve as a guide for reassembly.

1-Make certain Flywheel is machined and all parts absolutely clean.

2-Use a clutch aligning tool to center the disc with the pilot bearing. The stamp "FW SIDE" should be toward the flywheel.

3-Assemble cover to flywheel. Tighten cover bolts evenly, one turn at a time.

4-Install transmission using guide bolts to guide transmission into place. Input shaft should slide smoothly and easily through hub into pilot bearing. DO NOT FORCE. Rotate input shaft if necessary to align splines.

5-Follow manufacturer`s instructions to complete installation.

Price : $199.99